, ,
CNC Shield V3 Arduino in Pakistan

₨340 ₨300

  • Arduino UNO shield form factor, compatible with Arduino UNO, CT-UNO.
  • GRBL v1.1 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals)
  • Uses removable A4988 compatible stepper drivers (Not Included)
  • PWM Spindle and direction pins
  • 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins A4 and A3)
  • 2 x End stops for each axis (6 in total) + one Probe
  • Coolant enable output
  • Jumpers to set the Micro-Stepping for the stepper drivers.
  • Compact design.
  • Stepper Motors can be connected with 4 pin molex connectors or soldered in place.
  • Runs on 12-35V DC. (Depending on Stepper driver

Description

This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.
UNO for Arduino module IO port correspondence introduction.

 

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

0 WooCommerce Floating Cart

No products in the cart.

X